Influence of Blasting Disturbance on the Dynamic Stress Distribution and Fracture Area of Rock Tunnels

Abstract

In order to study the dynamic stress distribution and the fracture area of rock around the tunnel under different orientations of blasting disturbance, AUTODYN finite difference method software was used to conduct numerical simulation research. Gauge monitoring points were set around the numerical model of the tunnel to conduct real-time monitoring of the stress distribution, displacement and fracture area of the tunnel. Based on the analysis of the stress wave propagation law, the following conclusions are obtained: (1) under the condition of the same blasting loads, the stress and displacement of the tunnel is relatively small when the blasting disturbance source is located above the roof, i.e., the stress state of the tunnel is relatively stable and the fracture area around the tunnel is minimal; (2) from the uniaxial stress around the tunnel and the tunnel peripheral displacement, it can be seen that the displacement caused by horizontal direction stress of the tunnel is the largest, and the deformation is mainly concentrated above the floor and at the shoulder, while the vertical wall part has almost no deformation; (3) for brittle materials such as rock, the arch-shaped stress-bearing surface is more likely to disperse stress, while the straight wall and flat floor of the tunnel cannot well disperse stress, resulting in uneven stress on the stress-bearing surface, uncoordinated deformation and ultimately, failure.

Keywords

• blasting loads
• rock
• numerical simulation
• dynamic failure
• tunnel