Energy Science & Engineering (Dec 2019)
Effect of coal blending on ash fusion behavior for blast furnace injection of high calcium bituminous coal
Abstract
Abstract In order to expand the range of bituminous coal injected into blast furnace, the ash melting behavior and regulation mechanism of bituminous with high calcium and low ash fusion temperature (AFT) were investigated by coal blending. And the mineral transformation behavior in the blended ashes was investigated by X‐ray powder diffractometry with normalized reference intensity ratio software and FactSage software. The experimental results manifest that the softening temperature (ST) of coal D is 8°C lower than that of the hot blast temperature. By adequately mixing coal B and coal D, it is easy to meet the requirements of pulverized coal injection. And coal D has become a standard bituminous for blast furnace injection. However, the high content of CaO in the coal S ash makes the AFT much lower than the hot blast temperature, which leads to the reluctance of the steel industry to inject coal S. With the increase of coal B mass ratio, the content of high‐melting eutectic matters (3Al2O3·2SiO2 and tridymite) increases at high temperature, while the content of low‐melting anorthite, andradite, gehlenite, and grossularite decreases, which leads to the increase of AFTs. The variation in the liquid phase under certain conditions reflects the change in AFT. In summary, by blending with coal B, the ST of blended coals S/B is higher than the hot blast temperature (1250°C), so that coal S can be applied to blast furnace injection. And the injection ratio of coal S in blended coals can reach about 50%.
Keywords