Short-time induction heat treatment of high speed steel AISI M2: Laboratory proof of concept and application-related component tests

Abstract

High-speed steels (HSS) such as AISI M2 are generally used for cutting and forming tools or broaches with the highest demands on load bearability and hot-hardness. The requirements for high-speed steels are, on the one hand, extremely high hardnesses of over 800–900 HV and, on the other hand, the thermal stability of the microstructure up to 500 °C. This combination is achieved by complex precipitation-hardenable iron-based alloys. Common heat treatment practices for high-speed steels use salt baths or vacuum ovens, which are energetically unfavorable and require subsequent cleaning. The study consists of short-time hardening and short-time tempering on a laboratory scale by means of dilatometry and thereupon an implementation in an industrial induction hardening machine. The laboratory scale experiments demonstrate the feasibility of bringing sufficient alloying elements into solution by means of several heat treatment cycles despite short holding times of 1 s and less. Combined tests of short time hardening and tempering show a hardness of up to 850 HV10 that are competitive with the conventional heat treatment route. First attempts to transfer the process to an industrial setup exhibit some peculiarities in the process control, but reveal promising results with a surface hardness of up to 750 HV10.

Keywords

• High-speed steel
• Short-time hardening
• Short-time tempering
• Induction hardening
• Hardness
• Dilatometry