Defence Technology (Jun 2022)
Ballistic impact response of resistance-spot-welded (RSW) double-layered plates for Q&P980 steel
Abstract
Ballistic impact response of resistance-spot-welded (RSW) double-layered (2 × 1.6 mm) plates (190 mm × 150 mm) for Q&P980 steel impacted by a round-nosed steel bullet (12 mm diameter and 30 mm length) was investigated by using gas gun and high-speed camera system. The RSW specimens were spot welded using a 6 mm diameter electrode face producing a 7.2 mm diameter fusion zone of the spot weld. The ballistic curve and energy balance for the tests of the spot weld of the RSW specimens at different velocity were analyzed to characterize the ballistic behavior of the RSW specimens under bullet impact. The fracture mechanisms of the RSW specimens under bullet impact were presented. For the tests below the ballistic limit, the cracks initiated from the notch-tip and propagated along the faying surface or obliquely through the thickness depending on the impact velocity. For the tests above the ballistic limit, the plug fracture in the front plate of the RSW specimen could be caused by the thinning-induced necking in the BM near the HAZ, while the plug fracture in the rear plate of the RSW specimens may be consist of the circumferential cracking from the rear surface and the bending fracture of the hinged part of material. The effects of the electrode indentation and the weld interfaces on deformation and fracture of the RSW specimens under bullet impact were revealed. For the tests above the ballistic limit, the circumferential fracture from the rear surface of the RSW specimens was always initiated along the interior periphery of the electrode indentation and the crack paths were along the FZ/CGHAZ or CGHAZ/FGHAZ interface. When the circumferential crack also formed outside the electrode indentation, the fracture on the BM/HAZ interface could be found. On the front plate of the RSW specimens, the shear/bending induced cracking from the notch-tip were observed and the crack paths were along the FZ/CGHAZ or CGHAZ/FGHAZ interface.
