3D PRINTING APPLICATION IN BONE DEFECT AREA MEASUREMENT ON PATIENTS WITH DEVELOPMENTAL DYSPLASIA OF THE HIP

Abstract

ABSTRACT Objectives Evaluate the application value of 3D printing technology in measuring acetabular bone defect area in adult patients diagnosed with developmental dysplasia of the hip (DDH). Methods 23 cases of DDH requiring total hip replacement surgery were enrolled in this study. Preoperative examination confirmed the standard pelvic plain films Crowe, including 3 cases of Crowe I, 7 Crowe II, and 13 Crowe III. The 3D printing technology was used to print the hip model before the operation. Based on the pre-printed model, pre-operative planning and surgical procedures were established. The area of the acetabular bone defects was measured, the selected size prosthesis was recorded, and the surgery was performed (group A). The actual acetabular bone defect area and the prosthesis size were also recorded (group B). Results The comparative results indicated that the actual acetabular defect area measured intraoperatively and the area measured using the 3D printing technology did not significantly differ for all participants (all P>0.05). Conclusion Preoperative model can accurately measure the acetabular bone defect area for DDH. It is significant to develop individualized implants for DDH patients treated with the 3D printing technique. Level of Evidence IV: Case series.

Keywords

• Developmental Dysplasia of the Hip
• 3 D Printing
• Arthroplasty
• Replacement
• Hip