Analysis of Machinability on Properties of Inconel 718 Wire and Arc Additive Manufacturing Products

Abstract

Wire and arc additive manufacturing (WAAM) is a metal deposition technique with a fast rate and the possibility of a high volume of deposition. Because of its fast deposition and high heat input, the manufactured products have poor surface quality. This paper presents a study on the machining of Inconel 718 wall-shaped additive manufacturing (AM) products, a necessary step for the improvement of surface quality. Considering the possibility that the characteristics of the milling processes of AM products might differ from those of traditionally manufactured parts, in this research, two types of Inconel 718 were studied and compared: one was manufactured using WAAM, and the other was an Inconel 718 rolled bar (Aerospace Material Specifications 5662). Using the testing procedure, a conventional two-flute cutting tool was used to assess their machinability. For this process, multiple passes were performed at three different heights of the samples. Considering the peculiarities of the AM products, such as their uneven surfaces, dendritic microstructures, and anisotropy, the results were analyzed. After the machining operation, the effects on the products were also studied by analyzing their surface quality. This study found a higher stability in the cutting process for the AMS 5662 samples relative to the WAAM parts with less variability in the cutting forces overall, resulting in better surface quality.

Keywords

• additive manufacturing
• machining
• machinability
• surface quality
• cutting forces