Corrosion Resistance of Cu-Alloyed Precipitation Hardenable Duplex Stainless Steel ASTM A890 Grade 1B

Abstract

Duplex stainless steels (DSS) are corrosion resistant alloys largely used in chemical and petrochemical industries. Some commercial DSS contain 0.5-1.0% copper addition to improve the corrosion resistance by reducing the corrosion rate in non-oxidizing environments. Higher copper addition (≥ 2%) can also hard by precipitation, especially when fine copper precipitates (ε phase) are produced. In this work, a cast copper alloyed DSS type ASTM A890 grade 1B with 3.01%Cu was investigated. Different levels of hardness were produced by solution treatment and aging at 450, 500, 550 and 600 oC for periods of time up to 1 hour. The corrosion resistance of aged DSS was evaluated by electrochemical tests in three media: 0.6 mol/L NaCl, 0.3 mol/L H2SO4 and 0.6 mol/L NaCl + 0.3 mol/L H2SO4 solutions. The results indicate that the effect of Cu addition depends on the media studied. Polarization studies in 0.6 mol/L NaCl showed a small anodic current peak occurred at around 400 mV vs. Ag/AgCl, with a strong influence on the passive film stability. Additionally, chronoamperometric measurements at 400 mV vs. Ag/AgCl showed a high electrochemical activity for the samples in 0.6 mol/L NaCl.

Keywords

• Cast duplex stainless steel
• copper
• passive film