Fresh, hardened and thermal properties of coating mortars containing mineral additions and vermiculite

Abstract

Efforts are made to alleviate thermal problems in buildings. The use of thermal mortars for coating with vermiculite as aggregate is used for this purpose, but the use with mineral additions is still scarce, especially the rheology through squeeze-flow. Thus, it was aimed to evaluate the behavior in fresh, hardened state and in the thermal conductivity of these mortars. Mortars containing Portland cement, lime, vermiculite, sand, and additions of metakaolin or ceramic brick waste, in the proportion of 1:1:6 (Cement: Lime: Sand), were evaluated. The sand was replaced by vermiculite in 40%, and the additions added in the proportion of 20% to the cement mass, and the water content determined with the spread obtained on the consistency table. Mixtures containing 20% mineral addition and 40% vermiculite proved to be feasible, reaching minimum values according to the respective standards.

Keywords

• Thermal mortar
• Vermiculite
• Mineral additions
• Rheology
• Squeeze-flow