One-Step Hybrid Bending/Diffusion Bonding Process and Analysis of the Bonding Characteristics of Titanium Alloy Sheets

Abstract

A one-step hybrid bending/diffusion bonding process (HB/DBP) was developed for application to Ti-6Al-4V sheets to effectively improve buy-to-fly (BTF) ratio of aircraft parts, integrating sequential diffusion bonding followed by a bending process. The resulting bonding characteristics of these titanium alloy sheets were analyzed. Microstructural analysis and mechanical lap shear tests were performed to estimate the bonding quality. Additionally, bonding ratio, thickness strain, and shear strength were evaluated in relation to pressure under increasing temperature. When the applied pressure was lower than 0.5 MPa, early failure occurred at the joint of the specimens. However, when high pressure was applied, early failure occurred near the joint. To discuss the phenomenon, time-dependent viscoplastic material properties were characterized, and a numerical simulation analysis was performed. Viscoplastic deformation was observed around the bending area, which caused weakness around the bond under high-pressure conditions. A prototype of a Y-shaped heat shield was manufactured and the buy-to-fly ratio was effectively improved using the newly developed process. This study demonstrates the potential of applying the developed process for producing aircraft parts and the importance of viscoplastic behavior for the analysis of final product reliability.

Keywords

• one-step hybrid bending/diffusion bonding process
• titanium alloy sheets
• numerical simulation
• viscoplasticity
• aircraft parts