Metals (Aug 2023)

On the Control of Elemental Composition, Macro-, and Microstructure of Directionally Solidified Additive Products from Nickel-Based Alloy

  • Sergey Fortuna,
  • Denis Gurianov,
  • Sergey Nikonov,
  • Kseniya Osipovich,
  • Evgeny Kolubaev

DOI
https://doi.org/10.3390/met13081457
Journal volume & issue
Vol. 13, no. 8
p. 1457

Abstract

Read online

The present work establishes the influence of heat input and methods of heat removal at the wire-feed electron beam additive manufacturing (EBAM) process on the structure of an additive product made of a nickel-based alloy. The following printing approaches are considered: changes in heat input, 3D printing strategy, and heat removal conditions due to (1) heating of the substrate, (2) partial suppression of radiative heat dissipation, and (3) thermal insulation of the substrate. It is shown that epitaxial growth of dendrites occurs in each case. However, in the case of an increase in speed and a change in the 3D printing strategy, the directed dendritic growth is interrupted. Preheating of the substrate and subsequent maintenance of the temperature reached during the EBAM process, as well as partial suppression of the radiative component of heat removal, allow to obtain the most uniform directional structure.

Keywords