Evaluations and Measurements of the Occurrence of Maxilla and Palatine Bone Asymmetry Based on 3D Printed Stereolithographic Models in Elderly Edentulous People

Abstract

This study aimed to evaluate and measure the occurrence of jaw and palate asymmetry based on 3D-printed stereolithographic models of edentulous elderly people. The analyses were performed on 3D models of the jaws, which were printed using the data (CT) obtained from the CBCT center. The control group consisted of 10 modern adult skulls (7 male and 3 female skulls) owned by the Department of Anthropology of the Wrocław University of Environmental and Life Sciences. The small size of the studied groups did not allow for the performance of the analysis indicating the form of the observed morphological asymmetry—it was impossible to differentiate to indicate whether the examined features showed directional or fluctuating asymmetry. However, it was possible to determine the direction of the morphological asymmetry of the analyzed features. Both in the test group and the control group, it was a right-sided asymmetry. The analysis of the significance of differences in mean values of the asymmetry index showed that the intensity of asymmetry of the anterior part of the superior alveolar arch was significantly greater in the test group. The severity of the asymmetry of the lateral part of the alveolar arch in the tested groups did not differ significantly. The authors concluded that adequate maxillary height does not only influence proper dental prosthesis adhesion but also corresponds with a potential source for correct dental implant placement. We also concluded that the vertical height of the edentulous alveolar process of the mandible is important for adequate prosthesis fixing. In some cases, the bone atrophy and the bone itself are asymmetrical, so planning a prosthesis might be challenging. The adequate placement of implants should include the symmetry of jaw bones because of future masticatory force impact on the bone and the entire masticatory system, including the temporomandibular joint.

Keywords

• maxilla
• palatine bone
• 3D printed models
• cranium
• craniometric measurements
• asymmetry