Characteristics of electrospun chitosan/carbon nanotube coatings deposited on AZ31 magnesium alloy

Abstract

Abstract Mg-based biomaterials are commonly used as biodegradable orthopedic implants (e.g., bone regeneration applications). However, achieving high biocompatibility and corrosion resistance has remained a challenge to be tackled. In this work, to investigate various fabricated coatings (with and without pre- anodizing), five categories of samples are considered: (a) bare Mg alloy (Mg), (b) Anodized Mg alloy (Mg-A), (c) CS-coated Mg alloy (Mg-C), (d) CS-coated anodized Mg alloy (Mg-AC), and (e) CS-CNT-coated anodized Mg alloy (Mg-ACC). These samples were characterized by using Field Emission Scanning Electron Microscopes (FE-SEM), Energy Dispersive Spectroscopy (EDS), Fourier Transform Infrared Spectroscopy (FT-IR), and Raman Spectroscopy. The adhesion within the coated samples was compared. Then, the effects of the coatings were evaluated by comparing wettability, corrosion behavior, and biocompatibility for bare and coated samples. The adhesion test showed that the coatings exhibited higher adhesion for Mg-AC and Mg-ACC compared to Mg-C. Desired wettability was achieved as the contact angles of coated samples were in the range of 55°– 65°. Electrochemical impedance and polarization as well as immersion tests showed higher corrosion resistance for coated samples. The composite coated sample showed improved cell adhesion since the osteoblast cells covered almost the entire surface of the sample. Moreover, osteoblast cell viability for the sample was around 40% higher than that of the bare sample. Graphical abstract

Keywords

• Magnesium
• Nanocomposite coating
• Chitosan
• Carbon nanotubes
• Nanofiber