Time Dependence of Wetting Behavior Upon Applying Hierarchic Nano-Micro Periodic Surface Structures on Brass Using Ultra Short Laser Pulses

Abstract

We present a comprehensive experimental study on laser-induced hierarchic nano-micro periodic surface structures on brass that influences wetting behavior. Using ultra short laser pulses with a wavelength of 1030 nm, large scaled areas completely covered by laser-induced periodic surface structures (LIPSS) are generated with these areas being superimposed by ablation trenches and u-ripples. The influence of the incident laser fluence and pulse overlap on the apparent contact angle for coverage of the surface with distilled water with a surface tension of 74 mN/m are examined with its temporal evolution being observed over a period of two weeks. Our results show an initial drop in the apparent contact angle below the angle of an unstructured surface. Using atomic force microscopy, the roughness factor described by the Wenzel model is determined and compared to the roughness factor given by the apparent contact angle measurement. The ascertained difference in roughness cannot be entirely attributed to the topography of the laser-structured surface. We suggest that changes in the surface chemistry additionally alter the wetting behavior as confirmed by X-ray photoelectron spectroscopy (XPS) measurements. On a time scale of days after laser irradiation, the apparent contact angle increases into the hydrophobic range. Both the absolute apparent contact angle and this temporal change reveal a pronounced dependence on the applied laser fluence and pulse overlap. In particular, increasing both, the fluence and the pulse overlap leads to smaller apparent contact angles directly after the irradiation and to higher apparent contact angles after an observation period of two weeks.

Keywords

• wettability
• time dependence
• laser-induced periodic surface structures