CONSERVATIVE IDIOPATHIC SCOLIOSIS TREATMENT WITH BRACE PRODUCED USING 3D TECHNOLOGY

Abstract

ABSTRACT Objective To evaluate the immediate correction capacity of the Wood-Chêneau-Rigo brace (WCR), produced using digital technological resources and robotic engineering, in primary and secondary curves of adolescent idiopathic scoliosis (AIS). Methods A retrospective study was conducted of 138 patients with a diagnosis of AIS and who received a WCR brace from a laboratory that makes orthoses and orthopedic prostheses between 2019 and 2021. These individuals were submitted to an independent analysis of the radiographic parameters by a single researcher, the main outcome of which was the standardized measurement of the main and secondary curves using the Cobb method. The radiographs analyzed were performed in orthostasis before and immediately after the adaptation of the brace on the patient. The correction capacity was calculated as the ratio of the difference between the pre- and post-brace curves to the pre-brace curve. Results The mean correction with the WCR was 48.4% for the main curve and 41.0% for the secondary curve. The level of correction of the main curve was significantly higher in patients with a main curve with the apex of convexity in the thoracolumbar region (p = 0.004), especially in the left thoracolumbar region (p = 0.010); curves of magnitude between 10º and 24.9º (p <0.001); and curves classified as simple (p <0.001). Conclusion The use of the WCR, which is produced using modern technological resources, was effective in the immediate correction of AIS. Long-term studies on this new modality of conservative scoliosis treatment are necessary. Level of evidence III; Retrospective study.

Keywords

• Scoliosis
• Conservative Treatment
• Variance Analysis