Application of Photo, Peracetic Acid, and Combination Pre-treatments in Improving Totally Chlorine-Free Bleaching Selectivity

Abstract

The application of totally chlorine-free bleaching (TCF) is well recognised for its environmental compatibility. However, its application is restricted in comparison to a chlorine-based bleaching sequence. TCF bleaching produces pulp with relatively lower brightness and strength properties. Oxygen delignification (O-stage) is commonly used as a first bleaching stage; therefore its selectivity influences TCF bleaching performance. In this study, the selectivity of the O-stage and hydrogen peroxide-reinforced O-stage (Op-stage) on tropical hardwood kraft pulp were 0.53 and 0.71, with 37.8% and 55.5% kappa number (Kn) reductions, respectively. The addition of photo pre-treatment prior to the O-stage and Op-stage improved the Kn reduction to 53.7% and 59.2%; consequently the selectivity was enhanced to 1.0 and 0.73, respectively. The Fourier transform infrared spectra showed that photo pre-treatments improved the selectivity by protecting the cellulose from carbonyl-induced degradation. This protective effect was more prominent in the O-stage than the Op-stage. However, the combination of peracetic acid and photo treatment did not further increase bleaching selectivity in either stage. In short, blue light and UV irradiation treatment with or without the prior addition of peracetic acid to ordinary or hydrogen peroxide-reinforced oxygen delignified pulp displayed a similar bleaching effect on the resultant pulp.

Keywords

• Oxygen delignification
• Peroxide reinforcement
• Photo and peracetic acid pre-treatment
• Selectivity
• Pulp viscosity
• Fourier transform infrared spectroscopy (FTIR)