Comparison of Mechanical Properties According to the Structural Materials of Lumber, GLT, CLT, and Ply-lam CLT

Abstract

The mechanical properties of materials such as lumber (L), glued laminated timber (GLT), cross-laminated timber (CLT), and Ply-lam CLT (P), which are laminated in cross layers, were compared. As a result, the modulus of elasticity (MOE) was 9.7 to 10.3 GPa, showing no significant difference between the materials. Modulus of rupture (MOR) of L and GLT showed higher strength than that of CLT and P. MOR of CLT and P was at the same level, and there was no difference in strength according to the plywood and lumber arranged alternately. Alternatively, there was a difference in the coefficient of variation of the materials, and CLT and P was 20.2% and 11.8%, respectively; therefore, uniform properties can be secured when using plywood. The compression strength showed the highest compression strength in the order of GLT, L, P, and CLT. P was failure by buckling+delamination, but other materials showed failure by only buckling. The adhesion of P passed the glulam standard (7.0 MPa), and the delamination ratio was very low at 0.41%. It can be used together with CLT. This study is expected to be used as basic data for establishing quality standards.

Keywords

• lumber
• glued laminated timber
• cross-laminated timber
• ply-lam clt
• bending properties
• compression strength
• failure mode
• block shear strength
• delamination rate