Selection of cutting parameters for the machinability of Inconel 718 using Grey Relational Analysis

Abstract

Inconel 718 is considered to be most difficult to machine superalloy because of its high shear strength, work hardening and precipitation hardening. Abrasive particles which are in microstructure have tendency have forming chip to be welded to tool and form built up edge (BUE) making it more difficult to machine. Friction between tool and material and its low thermal conductivity results in high temperature generation. Certain tools such as Ceramics are present which machine this material at prime cutting conditions. This paper addresses the cutting parameters needed most for providing low surface roughness

Keywords

• Friction Stir Welding
• Destructive Test (DT)
• Non-Destructive Test (NDT)