Adherence of Brazilian dimension stones by mortar adhesion: influence of temperature

Abstract

The influence of temperature variation on the adherence of granite slabs was simulated by a set of TBS tensile bond strength tests carried out using three types of rocks of established commercial use and with good technological qualities, known as “Branco Desireé”, “Vermelho Capão Bonito” and “Cinza Andorinha”. Specimens of these materials were fixed with two types of adhesive mortars, one commercial and the other produced in the laboratory, with white cement CPI. After the standardized cure, 186 TBS tests were carried out in 5 temperature ranges laboratory-controlled, ranging from 23 °C to 60 °C. The test results showed the temperature increase implies the loss of tensile strength. The commercial mortar presented TBS final values lower or nearby to 1 MPa, the standard threshold for ceramic slabs. The mortar prepared with white cement showed better performance, with adherence values above the 68% mentioned limit. This expressive result recommends the continuation of research with other types of rocks fixed with mortar prepared with white cement. The microstructure behavior of the material sets subjected to adherence tests was also investigated. The inspections showed clear contact between the stone plates (with both rough and smooth contact surfaces), without the occurrence of reaction edges or pervasion of the mortar in the stone. Anchoring, therefore, took place only in the contact between the standard substrate and mortar.

Keywords

• Granite
• Mortar
• Adhesion