Investigation of the Destruction Process of Potash Ore with a Single Cutter Using Promising Cross Cutting Pattern

Abstract

The creation of modern machines and improvement of existing designs of rock cutting bodies of combines is constrained by the lack of experimental studies of the process of separation of successive elementary cleavages during the potash ore cutting with cutters of winning machines. The potential of the cross cutting pattern of potash ore is shown, since the formation of zones of localization of weakening and induced fractures on the surface of layer-by-layer cutting face determines the separation of the elementary cleavages with stable geometric parameters. The verification of the conclusions obtained theoretically was carried out during laboratory tastings on a specially designed bench. The research procedure provided for comparative tests of the potash block ore cutting, staggered and cross cuttings. It has been proven that the use of the cross pattern for set cutting parameters makes it possible to reduce the specific energy costs of the cutting of potash mass, to reduce the average load on the cutter, to reduce the root-mean-square deviation, and to reduce the number of fractions that are hard to enrich in the crushing products, compared to the traditional staggered cutting pattern.

Keywords

• destruction of potash ore
• cutting
• cross cutting pattern
• experimental studies
• laboratory bench