Direct artificial aging of the PBF-LB AlSi10Mg alloy designed to enhance the trade-off between strength and residual stress relief

Abstract

The AlSi10Mg alloy is one of the most studied alloys processed by the Powder Bed Fusion-Laser Beam (PBF-LB). Many already published works focus on post-process heat treatments to reduce residual stress or improve mechanical strength. Instead, the present study aims to identify direct artificial aging (AA) heat treatment able to optimize both aspects, thus enhancing the trade-off between strengthening and residual stress relief for the PBF-LB AlSi10Mg alloy produced using a no-heated platform. Higher temperatures (190–240 °C) than those typically used in AA heat treatment were selected based on thermal analysis to benefit both residual stress relief and precipitation of reinforcing phases from the supersaturated solid solution of the metastable as-built alloy. The effects of AA heat treatment on mechanical properties (i.e. hardness) and residual stress were evaluated by plotting aging curves and by XRD and Raman analyses and demonstrated that different trade-offs between strengthening and stress relief can be achieved by tuning heat treatment parameters (temperature and time). In particular, the exposure at the lowest temperature (190 °C) induced a partial decrease in residual stress and a slight increase in hardness. By increasing heat treatment temperature and soaking time, the relief was more significant, whilst the decrease in hardness was rather limited. The results are supported by the microstructural changes observed on the samples due to the different heat treatment conditions applied and show the feasibility of designing an AA heat treatment for the PBF-LB AlSi10Mg alloy capable of satisfying the mechanical response required by the final application.

Keywords

• Additive manufacturing
• Aluminum alloys
• Microstructure
• Residual stress
• Mechanical properties
• Heat treatment