Energies (May 2024)

Solvent Exsolution and Liberation from Different Heavy Oil–Solvent Systems in Bulk Phases and Porous Media: A Comparison Study

  • Wei Zou,
  • Yongan Gu

DOI
https://doi.org/10.3390/en17102287
Journal volume & issue
Vol. 17, no. 10
p. 2287

Abstract

Read online

In this paper, experimental and numerical studies were conducted to differentiate solvent exsolution and liberation processes from different heavy oil–solvent systems in bulk phases and porous media. Experimentally, two series of constant-composition-expansion (CCE) tests in a PVT cell and differential fluid production (DFP) tests in a sandpacked model were performed and compared in the heavy oil–CO2, heavy oil–CH4, and heavy oil–C3H8 systems. The experimental results showed that the solvent exsolution from each heavy oil–solvent system in the porous media occurred at a higher pressure. The measured bubble-nucleation pressures (Pn) of the heavy oil–CO2 system, heavy oil–CH4 system, and heavy oil–C3H8 system in the porous media were 0.24 MPa, 0.90 MPa, and 0.02 MPa higher than those in the bulk phases, respectively. In addition, the nucleation of CH4 bubbles was found to be more instantaneous than that of CO2 or C3H8 bubbles. Numerically, a robust kinetic reaction model in the commercial CMG-STARS module was utilized to simulate the gas exsolution and liberation processes of the CCE and DFP tests. The respective reaction frequency factors for gas exsolution (rffe) and liberation (rffl) were obtained in the numerical simulations. Higher values of rffe were found for the tests in the porous media in comparison with those in the bulk phases, suggesting that the presence of the porous media facilitated the gas exsolution. The magnitudes of rffe for the three different heavy oil–solvent systems followed the order of CO2 > CH4 > C3H8 in the bulk phases and CH4 > CO2 > C3H8 in the porous media. Hence, CO2 was exsolved from the heavy oil most readily in the bulk phases, whereas CH4 was exsolved from the heavy oil most easily in the porous media. Among the three solvents, CH4 was also found most difficult to be liberated from the heavy oil in the DFP test with the lowest rffl of 0.00019 min−1. This study indicates that foamy-oil evolution processes in the heavy oil reservoirs are rather different from those observed from the bulk-phase tests, such as the PVT tests.

Keywords