Study on low-temperature drying characteristics of premodified sludge with calcium oxide and sawdust

ZHANG Qunli; WANG Han; WANG Baozhong; CHENG Xuanrui; ZHANG Qiuyue

doi:10.19965/j.cnki.iwt.2023-0988

Gongye shui chuli (Nov 2024)

Study on low-temperature drying characteristics of premodified sludge with calcium oxide and sawdust

ZHANG Qunli,
WANG Han,
WANG Baozhong,
CHENG Xuanrui,
ZHANG Qiuyue

Affiliations

ZHANG Qunli: Beijing Key Lab of Heating, Gas Supply, Ventilating and Air Conditioning Engineering, Beijing University of Civil Engineering and Architecture, Beijing100044, China
WANG Han: Beijing Key Lab of Heating, Gas Supply, Ventilating and Air Conditioning Engineering, Beijing University of Civil Engineering and Architecture, Beijing100044, China
WANG Baozhong: Beijing Key Lab of Heating, Gas Supply, Ventilating and Air Conditioning Engineering, Beijing University of Civil Engineering and Architecture, Beijing100044, China
CHENG Xuanrui: Beijing Key Lab of Heating, Gas Supply, Ventilating and Air Conditioning Engineering, Beijing University of Civil Engineering and Architecture, Beijing100044, China
ZHANG Qiuyue: Beijing Key Lab of Heating, Gas Supply, Ventilating and Air Conditioning Engineering, Beijing University of Civil Engineering and Architecture, Beijing100044, China

DOI: https://doi.org/10.19965/j.cnki.iwt.2023-0988
Journal volume & issue: Vol. 44, no. 11
pp. 99 – 105

Abstract

Read online

Heat pump drying is a low-carbon and energy-saving sludge drying method. The operating temperature of heat pump is generally no more than 70 ℃. In order to improve the drying rate of sludge at low-temperature, the effects of air parameters and additives on sludge drying characteristics at low-temperature were studied by experimental research and data analysis methods. Experimental results showed that when the air temperature was 50-70 ℃ and the air velocity was 0.5-1.7 m/s, increasing the air temperature, air velocity and the additive ratio could accelerate the drying process of sludge. The average and maximum drying rates of CaO and sawdust premodified sludge were increased by 14.2% and 25.7%, respectively, compared with pure sludge. Two-way analysis of variance (ANOVA) showed that drying temperature had a greater impact on sludge drying than air velocity. Through non-linear curve fitting, the dynamic model of sludge drying process with temperature and air velocity changes was constructed, which provided a data basis for sludge drying under low-temperature conditions.

Published in Gongye shui chuli

ISSN: 1005-829X (Print)
Publisher: Editorial Office of Industrial Water Treatment
Country of publisher: China
LCC subjects: Technology: Environmental technology. Sanitary engineering
Website: http://www.iwt.cn/EN/home

About the journal

Abstract

Keywords