Наука и техника (Apr 2009)

SECTIONAL AREA CALCULATION OF MATERIAL REMOVED FROM BLANK WHILE FORMING SPACE BETWEEN TWO TEETH OF SATELLITE GEAR OF PLANETARY PIN TOOTH REDUCER

  • N. G. Yankevich,
  • E. N. Yankevich

Journal volume & issue
Vol. 0, no. 2
pp. 63 – 66

Abstract

Read online

One of the most important values while forming gear wheels is a material section area Sс which is to be removed by a tool in the process of forming a space between two teeth in one pass. Cutting resistance which is proportional to section area of the layer to be cut and, correspondingly, a thermodynamic intensity in the polishing zone depend on Sс value.The paper proposes relations for calculation of a material section area Sс which is to be removed from a blank while forming a space between two teeth of a satellite gear of a planetary pin tooth reducer.Measurements being made in the AutoCAD packet have shown that any corrections of the profile do not make a significant influence on a section area Sс.