Nanoscale Research Letters (Mar 2019)

Microstructure and Mechanical Properties of Graphene Oxide-Reinforced Titanium Matrix Composites Synthesized by Hot-Pressed Sintering

  • Jingqi Liu,
  • Ning Hu,
  • Xuyang Liu,
  • Yaolu Liu,
  • Xuewei Lv,
  • Liangxiao Wei,
  • Shoutao Zheng

DOI
https://doi.org/10.1186/s11671-019-2951-9
Journal volume & issue
Vol. 14, no. 1
pp. 1 – 12

Abstract

Read online

Abstract Ti matrix composites reinforced with 1–5 wt% graphene oxide (GO) were prepared by hot-pressed sintering in argon atmosphere. The effect of sintering temperature on the microstructures and mechanical properties of the composite was also evaluated. The results show that TiC nanoparticles were formed in situ as interfacial products via the reaction between Ti and GO during sintering. With increases in GO content and sintering temperature, the amount of TiC increased, improving the mechanical properties of the composites. GO was also partly retained with a lamellar structure after sintering. The composite reinforced with 5 wt% GO exhibited a hardness of 457 HV, 48.4% higher than that of pure Ti at 1473 K. The Ti-2.5 wt% GO composite sintered at 1473 K achieved a maximum yield stress of 1294 MPa, which was 62.7 % higher than that of pure Ti. Further increasing the GO content to 5 wt% led to a slight decrease in yield stress owing to GO agglomeration. The fracture morphology of the composite reinforced with GO exhibited a quasi-cleavage fracture, whereas that of the pure Ti matrix showed a ductile fracture. The main strengthening mechanism included grain refinement, solution strengthening, and dispersion strengthening of TiC and GO.

Keywords