Production of Aerated Foamed Concrete with Industrial Waste from the Gems and Jewels Sector of Rio Grande do Sul-Brazil

Abstract

The use of solid waste for the development of new building materials has been an alternative to reduce environmental impacts through the preservation of natural resources. In this context, this paper evaluates the possibility of using agate gemstone waste, called rolled powder, which basically consists of silica (SiO2), in the manufacture of aerated foamed concrete blocks completely replacing the natural sand. Preformed foam was used as the air entrained by mechanical stirring with a mixture of natural foaming agents derived from coconut. To produce test specimens, the water/cement ratio and foam concentrations were varied, with three and four levels, respectively. The specimens were left for 28 days at room temperature to be cured, and then underwent analysis to determine their compressive strength, density, and the distribution of air-voids. The experiments demonstrated that the best water/cement ratio was 1.28 for 18% (of total solid mass) addition of foam, which generated a sample with a density of 430 kg/m3, and a compressive strength of 1.07 MPa. The result for compressive strength is 11% smaller than the requirements of the Brazilian standard (NBR 13438) for autoclaved aerated concrete blocks, but the results are promising.

Keywords

• agate waste
• foaming agent
• aerated concrete block