Analysis of Edge Drop on Strip Due to Bending and Elastic Deformation of Back up Rolls in a Four-High Cold Mill

Abstract

The superficial quality of the strip is a very important issue in steel production. Considering the dimensions, the thickness is one of the most important variables in the production of a strip. In the present study, the elastic curve of Back Up Rolls (BURs) is analyzed, considering them as simply supported beams as well as the effect of rolls on the profile of the strip, specifically in the strip edge producing edge drop. The analysis included theoretical and numerical measurements in the mill. The results showed that there is an instability zone of 76 mm in the strip edge, and this geometry is symmetrical in both ends of the strip. This study not only provides a theoretical basis for the edge drop, but also provides a basis for the understanding of deformation on rolls used in rolling mill processes and their effect on the thickness, profile, shape, and dimensional quality of strips. To reduce the edge drop and significantly improve the surface quality of the strip, it is suggested to complement the simulation by compensating for the elastic curve of BUR, in the process applying bending on Work Roll (WR) combined with the use of positive crowns on it.

Keywords

• drop edge
• elastic curve
• four-high mill
• strip edge
• thickness of strip