A Bimodal Hydrostatic Actuator for Robotic Legs with Compliant Fast Motion and High Lifting Force

Abstract

Robotic legs, such as for lower-limb exoskeletons and prostheses, have bimodal operation: (1) within a task, like for walking (high speed and low force for the swing phase and low speed and higher force when the leg bears the weight of the system); (2) between tasks, like between walking and sit–stand motions. Sizing a traditional single-ratio actuation system for such extremum operations leads to oversized heavy electric motor and poor energy efficiency at low speeds. This paper explores a bimodal actuation concept where a hydrostatic transmission is dynamically reconfigured using custom motorized ball valves to suit the requirements of a robotic leg with a smaller and more efficient actuation system. First, this paper presents an analysis of the mass and efficiency advantages of the bimodal solution over a baseline solution, for three operating points: high-speed, high-force, and braking modes. Second, an experimental demonstration with a custom-built actuation system and a robotic leg test bench is presented. Control challenges regarding dynamic transition between modes are discussed and a control scheme solution is proposed and tested. The results show the following findings: (1) The actuator prototype can meet the requirements of a leg bimodal operation in terms of force, speed, and compliance while using smaller motors than a baseline solution. (2) The proposed operating principle and control schemes allow for smooth and fast mode transitions. (3) Motorized ball valves exhibit a good trade-off between size, speed, and flow restriction. (4) Motorized ball valves are a promising way to dynamically reconfigure a hydrostatic transmission while allowing energy to be dissipated.

Keywords

• robotic leg
• wearable robot
• legged locomotion
• dual-speed actuator
• hydrostatic transmission
• two-speed transmission