The metallurgical behaviors and crystallographic characteristic on macro deformation mechanism of 316 L laser-MIG hybrid welded joint

Abstract

A 10 mm 316 L stainless steel plate was joined using multi-layer laser-MIG hybrid welding. Results showed that unmixed zone and “real” fusion zone (FZ) existed near the fusion line. Frequently met dendritic ferrite (δ) and newly encountered spherical nanoscale particles trapped in austenite (γ) were only observed in the latter region. Chemically, these particles turned out a SiO2 phase. From base metal to FZ, δ morphology was altered from originally linear to relatively diversely dendritic. Meantime, γ exhibited a converse manner where previously randomly oriented equiaxed was replaced by coarse, columnar and textured. Accordingly, a comparably high Schmidt factor in γ phase was obtained in FZ. Moreover, δ exhibited a relatively higher stress level than γ which presented a decrease in residual stress with grain coarsening in heat affected zone. In FZ, δ fraction displayed a dramatical increase with special BCC-FCC orientation relations established. Finally, tensile test and fracture appearance implied that FZ was exactly the weakest link of the whole welded joint in spite of a qualified strength achieved. In summary, lack in Σ3, largely increased δ fraction, high Schmidt factor in γ and especially being rich in SiO2 particles collectively led to the micro-void coalescence fracture in FZ.

Keywords

• Laser-MIG hybrid welding
• 316 L stainless steel
• Microstructure
• Microtexture
• Deformation mechanism