Separations (Nov 2023)
Rapid Determination of Five Residual Solvents in Ursodeoxycholic Acid Raw Materials
Abstract
The chromatographic conditions were optimized using headspace gas chromatography, and a simple and rapid method was established for the simultaneous determination of five residual solvents in ursodeoxycholic acid raw materials. The corresponding quality standards were revised. The research results demonstrate that by utilizing a capillary column with a stationary phase consisting of 5% phenyl-95% dimethylpolysiloxane (HP-5, 30 m × 0.32 mm, film thickness 1.0 µm) and a flame ionization detector in conjunction with a headspace injection system and a programmed temperature ramping method, satisfactory analytical results can be achieved. The specific operating conditions are as follows: an initial column temperature of 45 °C, followed by a column temperature increase at a rate of 5 °C per minute up to 60 °C, then a further increase at a rate of 10 °C per minute up to 100 °C, and finally a rapid increase at a rate of 40 °C per minute up to 200 °C, where it is held for 10 min. Nitrogen is employed as the carrier gas at a flow rate of 1 mL/min with a split ratio of 14:1. The headspace vial temperature is maintained at 100 °C, with a sample equilibration time of 45 min. The concentration of methanol ranged from 0.06 mg/mL to 0.3 mg/mL, and the concentrations of acetone, tert-butanol, ethyl acetate, and triethylamine showed a good linear relationship with the peak area within the range of 0.1 mg/mL to 0.5 mg/mL (r = 0.999); The quantitation limits for methanol, acetone, tert-butanol, ethyl acetate, and triethylamine were 4.2, 0.9, 1.5, 1, and 0.1 μg/mL, respectively, with detection limits of 1.2, 0.25, 0.025, 0.3, and 0.025 μg/mL, respectively. The recovery rates of each solvent ranged from 92.9% to 106.0%, with RSD% (n = 9) less than 3.8%; the method exhibited good repeatability, with RSD% (n = 6) less than 2.5%. Furthermore, the robustness is good. The established method is simple, accurate, specific, and highly sensitive, and can be used for the simultaneous and rapid determination of five residual solvents in ursodeoxycholic acid raw materials.
Keywords