Heliyon (Jul 2024)
Effect of ball milling time on Sr0.7Sm0.3Fe0.4Co0.6O2.65 perovskites and their application as semiconductor layers in dye-sensitized solar cells
Abstract
The practical utilization of TiO2 as a semiconductor in dye-sensitized solar cells (DSSCs) has been set back by poor visible light absorption, high charge carrier recombination, and low electrical conductivity, which reduce the power conversion efficiency (PCE) and sustainability of the device. In this respect, perovskites with excellent properties, such as large surface area, good optical properties, high electrical conductivity, and superior electrochemical stability, have recently emerged as promising alternatives capable of overcoming the drawbacks of TiO2. Herein, Sr0.7Sm0.3Fe0.4Co0.6O2.65 (SSFC) perovskites were prepared via the ball milling method at various milling times of 0, 5, and 10 h, and the obtained samples were denoted by SSFC-0, SSCF-5, and SSCF-10, respectively. Increasing the ball milling time led to a significant reduction in nanoparticle size and agglomeration, which, in turn, increased the surface area and electrical conductivity of the samples. As a consequence, the SSFC-10 perovskite exhibited the smallest average particle sizes (18.9 nm) with the largest surface area (61.8 m2 g−1) and minimum defects, which allowed for efficient electron transport, resulting in the best electrical conductivity of 49.8 S cm−1. Ultimately, DSSCs fabricated using SSFC-10 semiconductor layers achieved an optimum PCE of 6.01 %, which is an improvement of 8.67 %, 1.1 %, and 6.56 % for SSFC-0 (3.69 %), SSFC-5 (4.96 %), and TiO2 (5.64 %), respectively. Thus, varying the ball milling time can be used as an effective technique to tailor the physicochemical properties of SSFC to suit desired applications, particularly the fabrication of highly efficient and sustainable DSSC semiconductor layers.
