Auxetic cementitious composites (ACCs) with excellent compressive ductility: Experiments and modeling

Abstract

Auxetic cementitious composites (ACCs) with improved mechanical properties are created, by casting 3D printed polymeric auxetic reinforcement structures inside cementitious mortar. Four types of ACCs incorporating reinforcement with different auxetic mechanisms were prepared: “re-entrant” (RE), “rotating-square” (RS), “chiral” (CR) and “missing-rib” (MR). Experiments and finite element models were used to study the compressive behavior of the ACCs. The results indicate that all ACCs have high compressive ductility. Specifically, the RE shows the highest ductility, manifested by 853% and 708% higher energy absorption than the reference mortar and the auxetic structure itself, respectively. In addition, the RE and RS are found to exhibit stronger crack-arresting effect under compression. Therefore, they achieved comparable compressive strength to the reference mortar, which is considerably higher than CR and MR. Furthermore, decreasing the volumetric ratio of the auxetic structure by half, the ductility of the RS reduces by 32.2%, while decreasing the water-to-binder ratio of the cementitious matrix from 0.4 to 0.3 only increases the compressive strength by 18.5%. Moreover, the two-dimensional finite element analyses used herein show a good match with experiments but become less accurate at high strain levels, due to their inability to capture the out-of-plane failure of the ACCs.

Keywords

• Auxetic structures
• 3D printing
• Cementitious composites
• Mechanical properties