Finite Element Analysis of Deformation and Stress Situation of Triangular Truss Under Different Loads

Abstract

In this paper, the two methods for solving finite element problem, theoretical calculation method and ANSYS simulation analysis method, were used to study deformation and stress situation of each node of triangular truss under different distribution loads. The results of theoretical calculation were compared with those of ANSYS simulation, which showed that the counter-acting forces of each node were exactly the same. For the calculation results of the equivalent stiffness constants of each unit could not be accurate, values of each node deformation calculated by theoretical calculation could be error, but the maximum error rate was no more than 3.6%. By the comparison results, conclusion could be made that the results of ANSYS simulation are more intuitive and image, the values are more accurate and reliable, comparing with those of theoretical calculation, the influence of accuracy of equivalent stiffness constant is much more smaller.