FPGA-Embedded Smart Monitoring System for Irrigation Decisions Based on Soil Moisture and Temperature Sensors

Abstract

The basic need common to all living beings is water. Less than 1% of the water on earth is fresh water and water use is increasing daily. Agricultural practices alone require huge amounts of water. The drip technique improved the efficiency of water use in irrigation and initiated the introduction and development of fertigation, the integrated distribution of water and fertilizer. The past few decades have seen extensive research being carried out in the area of development and evaluation of different technologies available to estimate/measure soil moisture to aid in various applications and to facilitate the use of drip irrigation for users and farmers. In this technology, plant moisture and temperature are accurately monitored and controlled in real time over roots in the form of droplets, by developing smart monitoring system to save water and avoid water waste using drip irrigation technology. Water is delivered to the roots drop by drop, which saves water as well as prevents plants from being flooded and decaying due to excess water released by irrigation methods such as flood irrigation, border irrigation, furrow irrigation, and control basin irrigation. Drip irrigation with an embedded intelligent monitoring system is one of the most valuable techniques used to save water and farmers’ time and energy. In this paper, we design an embedded monitoring system based in the integrated 65 nm CMOS technology in agricultural practices which would facilitate agriculture and enable farmers to monitor crops. Hence, to demonstrate the feasibility, a prototype was constructed and simulated with modelsim and validated with nclaunch the both tools from Cadence, as well as implementation on the FPGA board, was be performed.

Keywords

• smart monitoring system
• irrigation
• CMOS
• FPGA
• embedded system