Polymers (Oct 2021)
Thermal Behavior of Mixed Plastics at Different Heating Rates: I. Pyrolysis Kinetics
Abstract
The amount of generated plastic waste has increased dramatically, up to 20 times, over the past 70 years. More than 50% of municipal plastic waste is composed of polystyrene (PS), polypropylene (PP), and low-density polyethylene (LDPE) products. Therefore, this work has developed a kinetic model that can fully describe the thermal decomposition of plastic mixtures, contributing significantly towards the efficiency of plastic waste management and helping to save the environment. In this work, the pyrolysis of different plastic mixtures, consisting of PP, PS, and LDPE, was performed using a thermogravimetric analyzer (TGA) at three different heating rates (5, 20, and 40 K/min). Four isoconversional models, namely Friedman, Flynn–Wall–Qzawa (FWO), Kissinger–Akahira–Sunose (KAS), and Starink, have been used to obtain the kinetic parameters of the pyrolysis of different plastic mixtures with different compositions. For the equi-mass binary mixtures of PP and PS, the average values of the activation energies were 181, 144 ± 2 kJ/mol obtained using the Freidman and integral (FWO, KAS, and Starink) models, respectively. However, higher values were obtained for the equi-mass ternary plastic mixtures of PP, PS, and LDPE (Freidman: 255 kJ/mol, FWO: 222 kJ/mol, KAS: 223 kJ/mol, and Starink: 222 kJ/mol). The most suitable reaction mechanisms were obtained using the Coats–Redfern model. The results confirm that the most controlling reaction mechanisms obey the first-order (F1) and the third-order (F3) reactions for the pyrolysis of the equi-mass binary (PS and PP) and equi-mass ternary (PS, PP, and LDPE) mixtures, respectively. Finally, the values of the pre-exponential factor (A) were obtained using the four isoconversional models and the linear relationship between ln A and the activation energy was confirmed.
Keywords