Performance evolution of novel palm leaf powder used for enhancing hot mix asphalt

Abstract

Recently, researchers have been moving toward using local waste as an alternative for construction materials. Using these wastes to pave roads is one of the essential recycling methods, which aims to reduce the consumption of natural resources and environmental pollution resulting from the difficulty of decomposing these wastes. In the Middle East, especially in Iraq, Date Palm fiber is widely available as a local waste material. The aim of this research is to evaluate the performance of a developed asphalt mixture with palm leaf powder (PLP) as a partially substituted mineral filler. The Marshall mix design method produced the asphaltic mixes with ordinary Portland cement and PLP as mineral fillers. PLP was included in three rates denoted by 10, 20, and 30% by the weight of the mineral filler. Marshal stability, flow, bulk specific gravity, air voids, voids in mineral aggregates, voids filled with the binder, the indirect tensile strength, and the indirect tensile strength ratio of the PLP mixture were measured and compared with those of the conventional asphalt mixture. Based on the findings of this study, 20% of the Portland cement could be replaced with PLP, at which all of the properties of the enhanced mixture met the requirements of the Iraqi specifications. Then, the asphalt mix with 20% PLP was tested to assess its resistance against fatigue cracks. The results support the usage of waste PLP in pavement construction, enhancing its properties, which would also be very effective as an eco-friendly material.

Keywords

• hot mix asphalt
• mechanical properties
• palm leaf powder
• its
• tsr
• fatigue cracks
• four-point bending beam test