Crosslinked polyetherimide based electrospun membrane: Effect of fibre morphology on hot oil sorption

Abstract

Handling hot oil spillage, particularly from oil refineries, petrochemical industry and automobiles is challenging and there have been limited solutions to address the issue. Polyetherimide (PEI) electrospun fibrous membranes were developed in this study by leveraging PEI's high-temperature stability to serve as promising materials for hot oil sorption. The morphology of the membrane forming fibers varied from circular to dumbbell shaped, by judicious choice of solvents of varying boiling points, to study the effect of fiber morphology on oil sorption capacity. Crosslinking of PEI membranes was carried out using ethylenediamine (EDA) to impart structural integrity and resiliency to the membranes. The PEI membrane composed of dumbbell-shaped fibers demonstrated an oil-sorption capacity of 25.4 ±1.5 g/g for engine oil at 150°C within one hour, outperforming a commercial polypropylene (PP) nonwoven absorbent, which failed and collapsed under the same high-temperature conditions. Enhanced oil sorption in the dumbbell-shaped fibrous membrane was achieved due to its lower tortuosity, aligned inter-fiber channels, and higher capillary pressure. Usefulness and sorption capacity of PEI based electrospun membranes may further be explored for controlling the oil spillage through introduction of specific surface features and functionalization.

Keywords

• Polyetherimide
• Electrospinning
• Oil
• Sorption
• Membrane