Effects of Different Content of Phosphorus Slag Composite Concrete: Heat Evolution, Sulphate-Corrosion Resistance and Volume Deformation

Abstract

Phosphorus slag (PS) and limestone (LS) composite (PLC) were prepared with a mass ratio of 1:1. The effects of the content of PLC and the water/binder ratio on the mechanical properties, durability and dry shrinkage of concrete were studied via compressive strength, electric flux, sulfate dry/wet cycle method, saturated drainage method, isothermal calorimeter, adiabatic temperature rise instrument and shrinkage deformation instrument. The results show that PLC can greatly reduce the adiabatic temperature rise of concrete. The adiabatic temperature rise is 55 °C with 33 wt.% PLC, 10 °C lower than that of the control sample. The addition in the content of PLC does not affect the long-term strength of concrete. When the water/binder ratio decreases by 0.1–0.15, the long-term strength of concrete with PLC increases by about 10%, compared with the control group. At the age of 360 days, the chloride permeability of L-11 (i.e., the content of PLC was 20%, the water/binder ratio was 0.418) and L-22 (i.e., the content of PLC was 33%, the water/binder ratio was 0.39) decrease to the “very low” grade. The strength loss rate of L-11 and L-22 after 150 sulfate dry/wet cycles is about 18.5% and 19%, respectively, which is 60% of the strength loss rate of the control sample. The drying shrinkage of L-11 and L-22 reduces by 4.7% and 9.5%, respectively, indicating that PLC can also reduce the drying shrinkage.

Keywords

• phosphorus slag
• limestone
• concrete
• sulphate-corrosion resistance
• volume deformation