Factors Affecting Corrosion in Gulf of Finland Brackish Water

International Journal of Electrochemistry. 2016;2016 DOI 10.1155/2016/3720280

 

Journal Homepage

Journal Title: International Journal of Electrochemistry

ISSN: 2090-3529 (Print); 2090-3537 (Online)

Publisher: Hindawi Limited

LCC Subject Category: Science: Chemistry

Country of publisher: United Kingdom

Language of fulltext: English

Full-text formats available: PDF, HTML, ePUB, XML

 

AUTHORS

Jari Aromaa (Department of Materials Science and Engineering, Aalto University, P.O. Box 16200, Aalto, 00076 Espoo, Finland)
Olof Forsén (Department of Materials Science and Engineering, Aalto University, P.O. Box 16200, Aalto, 00076 Espoo, Finland)

EDITORIAL INFORMATION

Blind peer review

Editorial Board

Instructions for authors

Time From Submission to Publication: 7 weeks

 

Abstract | Full Text

The Baltic Sea is a relatively shallow inland sea surrounded by the countries of North-Eastern Europe and Scandinavia. The brackish water in the Baltic Sea has low salt concentration and it is typically one-sixth of the ocean seawater. The “nominal” amount of dissolved solids, upon which formulae for artificial seawater are based, is about 34,500 ppm, of which most is sodium chloride. The major constituents are those whose concentrations are greater than 1 mg/L and are not greatly affected by biological processes. The ratio of concentrations of these ions and molecules to each other is relatively constant. Corrosion rates were determined in long-term tests in Gulf of Finland brackish water off Helsinki. The water temperature varies through the year from about 0°C in January to 15-16°C in June to August. Salinity is 4–6‰, highest at the end of summer and lowest when ice melts. pH is between 7.0 and 8.1. Weight loss tests from one- to four-year tests for steel, stainless steel, copper, aluminium, zinc, and galvanized steel are reported and compared to short term laboratory tests in artificial seawater. Tests for passivation rates and crevice corrosion for stainless steel are discussed in terms of environment variation. The effect of corrosion on strength of steel is also discussed.