Post-irradiation vickers microhardness development of novel resin composites

Abstract

The aim of this study was to evaluate the effect of post-irradiation dry aging at different periods of time on Vickers microhardness of some dental composites based on various resin matrices. Sixty four disc-shaped specimens of the resin composites were prepared in a split Teflon mold (8 × 2 mm) and irradiated by Optilux 501 light cure (500 mW.cm-2 for 40 seconds) on their top side. The specimens were aged-dry in dark at 23 and 37 °C for the following storage periods; immediate, 1/2 an hour, 1, 6, 12, 24, 48 and 168 hours. The microhardness values were recorded using a Vickers Hardness Tester at 300 g load for 15 seconds. Results showed that Filtek® P90 and Definite expressed the highest hardness value followed by Tetric Evoceram and then Premise Enamel. At each aging period, all materials demonstrated significant differences between hardness values of top and base surfaces as well as both temperatures examined (P < 0.05). In conclusion, surface hardness developed gradually in most of the materials reaching optimum after 168 hours post-irradiation aging. Dental composites based on silorane and ormocer resin matrices achieved higher Vickers microhardness than those based on dimethacrylates resin.

Keywords

• post-irradiation aging
• vickers microhardness
• nanohybrid composites
• silorane
• ormocer