Heliyon (Oct 2023)
Investigation of catalytic reaction of ethylene dimerization to butene-1 by use of DCPDS as a modifier based on response surface methodology
Abstract
Butene-1 is one of the most important petrochemical industry products that is produced in different ways. Ethylene is an important source of Butene-1 production through the oligomerization process. In this study, to reduce the by-product of the polymer produced and to improve the catalyst yield, the dicyclopentyldimethoxysilane (DCPDS) modifier in the presence of a homogeneous titanium tetra butoxide/triethyl aluminum catalyst and a combination of dichloromethane (as a promoter) in a high-pressure Buchi reactor were used. Gas chromatography was used for liquid and gas phase analysis in the reactor. The design of experiments was performed with the Box-Behnken design technique (BBD) based on the response surface method (RSM). In this method, four effective factors of catalyst concentration, modifier, promoter, and temperature were evaluated. The results of the analysis of variance for the answers of ethylene conversion rate, selectivity, polymer production rate, and yield showed that there is a good agreement between the actual values and the values obtained from the model. Optimization using design expert software showed values of 85.6, 88.5, 2.43, and 75.78% for ethylene conversion rate, selectivity, polymer content and yield, respectively, which showed an error of less than one percent compared to the laboratory results. Comparison of the catalyst performance with and without DCPDS and DCM showed that the presence of these two compounds together with the catalyst, in addition to increasing by 4, 6, and 9% for conversion, selectivity of Butene-1 and yield, respectively, reduced the production of the undesirable polymer in the reactor from 136 mg to 2.4 mg.
