On the Use of Waste Materials for Thermal Improvement of 3D-Printed Block—An Experimental Comparison

Abstract

Over the years, the building envelope has evolved from a protective barrier element to a complex filter system capable of optimizing the interactions between the external and internal environments. An efficient envelope reacts flexibly to variable external conditions, minimizing heat losses in the winter season. Therefore, insulating materials play a fundamental role in building’s thermal performance. In this scenario, Additive Manufacturing represents an emerging and promising solution for the construction sector. Three-dimensional printing allows the creation of custom geometries, reduces material waste, and automates the construction process. This work aims to compare the thermal performance of a PLA (polylactic acid) 3D-printed block with an internal honeycomb structure whose air cavities are filled with natural and recyclable waste-insulating materials. The selected air cavity filling materials are (i) wood sawdust, (ii) sheep’s wool, and (iii) hemp. The thermal behavior of the block with the different filling materials was experimentally tested via Heat Flow Meter (HFM) method in a controlled environment (Hot Box). The results showed that the introduction of waste material significantly improved the thermal performance of the 3D-printed block compared to the case of air cavities. A thermal transmittance (U-value) reduction of up to 57% was obtained. Moreover, the sheep’s wool showed the best performance, with a U-value equal to 0.53 ± 0.02 W/m2K, i.e., 18.5% less than the wood sawdust and 19.7% less than hemp.

Keywords

• thermal insulation
• insulating materials
• air cavities
• 3D printing
• Hot Box analysis
• infrared thermography