Numerical study of full penetration single- and double-sided U-rib welding in orthotropic bridge decks

Abstract

Under the repeated action of residual stress and wheel load caused by welding, fatigue cracks easily occur on the top plate-U rib welding of an orthotropic bridge deck (OBD). These affect the service life. To study the influence of different full-penetration welding methods on the residual stress and fatigue of OBD, this study compared the residual stress, welding deformation, and fatigue performance of full-penetration single- and double-sided welding through finite element analysis. The welding temperature and residual stress fields were simulated based on Goldak's double ellipsoid heat source model using the thermal elastic-plastic method. The numerical results were verified using measured data from relevant literature, and the two were in good agreement. The results showed that the longitudinal residual stress of the double-sided welded U-rib was larger than that of the single-sided welded U-rib, primarily in the compressive stress range, and the maximum deviation reached 99.44 MPa. The longitudinal displacement of single-sided welding along the weld direction was 0.060 mm lesser than that of double-sided welding, and the maximum vertical displacement perpendicular to the weld direction was 2.457 mm lesser than that of double-sided welding. For the same frequency of fatigue load (wheel load), the fatigue strength of single-sided welding was larger than that of double-sided welding, and the fatigue life increased by 29.7%. In this study, analysis models of the full-penetration single-sided and full-penetration double-sided welding were established, which could provide a reference for structural fatigue assessment using the two full-penetration welding techniques under the influence of residual stress.

Keywords

• Orthotropic bridge deck
• Numerical simulation
• Full-penetration welding
• Residual stress
• Fatigue performance
• Thermal-mechanical coupling