Results in Engineering (Sep 2024)
Utilization of spent bleaching earth as green filler and plasticizer in the manufacture of rubber compounds for solid tire production
Abstract
This study utilized spent bleaching earth (SBE) as a single form of filler and plasticizer in the manufacture of rubber components for solid tire vulcanizate. SBE, an underutilized byproduct of vegetable oil purification, is abundantly available globally and can be used as a filler and plasticizer in rubber compounds. This aligns with environmental sustainability principles, reduces disposal costs, and lowers raw material expenses in rubber manufacturing. In this research, the SBE was applied for each formula from SBE-02 to SBE-05 at ratios of 15–30 per hundred rubber (phr). As a comparison, carbon black (CB) filler (65 phr), CaCO3 (35 phr), and plasticizer derived from petroleum in the form of paraffinic oil (PO) (6 phr) were used. Rubber components were produced by masticating natural and synthetic rubber in an open mill, followed by the addition of filler, plasticizer, accelerator, co-activator, anti-degradant, and vulcanization agent. The resulting compounds were vulcanized at 150 °C and 10 MPa for 17 minutes. The test results demonstrated that incorporating SBE at a ratio of 15 phr (SBE-02) significantly reduced the cure time (t90) to 8 minutes and 20 seconds, the shortest among all tested formulations. The mechanical properties of the SBE-02 vulcanizate rubber met the requirements for solid wheelchair tire applications, with a hardness of 70 Shore A. However, its abrasion resistance test result of 189.1 g/cm³ was the lowest among the formulations tested. Furthermore, the scorch time (ts2) of the SBE-02 was determined to be 2 minutes and 35 seconds. Results from a 1000x magnification scanning electron microscope (SEM) reveal air gaps on all sample surfaces of different sizes. The elements C, O, Zn, Si, Ca, and Pb dominate the SEM-EDX results for all rubber vulcanizate samples from all three spectra, in varying weight percentages. The identification of functional groups with FTIR on all rubber vulcanizate samples shows Si–O–Si bending at 2, 4, and 5 and Si–O–Al stretching at 3, 5 on the wave number spectrum of 680–413 cm−1 Si–O–Si on the wave number spectrum 1100–1050 cm−1 from the infrared spectrum.
