Microstructures and mechanical properties of additively manufactured Fe–21Mn-0.6C TWIP steel using laser powder bed fusion

Abstract

Twinning induced plasticity (TWIP) high manganese steel exhibits high ultimate tensile strength (UTS) and ductility, but its low yield strength restricts its applications. This research presents a Fe–21Mn-0.6C TWIP steel with enhanced mechanical properties additively manufactured using laser powder bed fusion (LPBF). The average grain size of the LPBF-fabricated Fe–21Mn-0.6C was 17.1 μm in the vertical direction, which was a quarter of that of a wrought one. The tensile yield strength was 657 MPa and the UTS was 1089 MPa with an elongation of 47.9% for the vertical direction. Compared to the wrought Fe–21Mn-0.6C, the yield strength increased by 110%. The high strength of LPBF-fabricated Fe–21Mn-0.6C is primarily attributed to solution, grain boundary and dislocation strengthening. Serrations were observed in the stress-strain curves at the initial stage of deformation, showing large stress drops. In the annealed sample, serrations appeared at a later stage of deformation with little stress drops. This difference in serration phenomenon is attributed to the varying dislocation density in the two samples.

Keywords

• Additive manufacturing
• TWIP steel
• Rapid solidification
• Microstructure
• Mechanical property