Simulation of a Power Skiving Gear Cutting Process

Hrytsay Ihor; Stupnytskyy Vadym; Slipchuk Andrii

doi:10.2478/scjme-2023-0008

Journal of Mechanical Engineering (May 2023)

Simulation of a Power Skiving Gear Cutting Process

Hrytsay Ihor,
Stupnytskyy Vadym,
Slipchuk Andrii

Affiliations

Hrytsay Ihor: 1Institute of Mechanical Engineering and Transport, Lviv Polytechnical National University, Department of Robotics and Integrated Mechanical Engineering Technologies, Bandery 12, 79013Lviv, Ukraine
Stupnytskyy Vadym: 2Institute of Mechanical Engineering and Transport, Lviv Polytechnical National University, Department of Robotics and Integrated Mechanical Engineering Technologies, Bandery 12, 79013Lviv, Ukraine
Slipchuk Andrii: 3Institute of Mechanical Engineering and Transport, Lviv Polytechnical National University, Department of Robotics and Integrated Mechanical Engineering Technologies, Bandery 12, 79013Lviv, Ukraine

DOI: https://doi.org/10.2478/scjme-2023-0008
Journal volume & issue: Vol. 73, no. 1
pp. 103 – 116

Abstract

Read online

The results of the computer simulation of the cutting process of gears by the power skiving method are presented. Following the kinematics of the process, a method for generating 3D geometric models of undeformed sheared layers were developed, and their parameters were analyzed. The influence of tool geometry and technological parameters on cutting conditions is investigated. The simulation results and calculation of the tangential force and torque on the tool axis and their influence on the error due to angular elastic deformation of the tool are given.

Published in Journal of Mechanical Engineering

ISSN: 2450-5471 (Online)
Publisher: Sciendo
Country of publisher: Poland
LCC subjects: Technology: Engineering (General). Civil engineering (General)
Website: https://sciendo.com/journal/SCJME

About the journal

Abstract

Keywords