Microstructure and Microhardness of Directionally Solidified Al-Si Alloys Subjected to an Equal-Channel Angular Pressing Process

Abstract

Abstract The directional solidification technique allows the study of growth of the solid phase, as-cast structure and, finally, its mechanical characteristics as a consequence of thermal parameters. On the other hand, in the last decade, a process called equal-channel angular pressing (ECAP) has emerged as a widely-known technique in fabrication of ultrafine-grained metals and alloys. Applicability of the ECAP technique affords an excellent potential for changing, in a controlled and beneficial manner, the resulting properties of metals and alloys. For this paper, an experimental research has been conducted to study the effects of solidification parameter (cooling rate) on resulting microhardness in hypoeutectic Al-Si alloys, upon use of an ECAP procedure. The influence of cooling on the scale of the dendritic patterns is presented and discussed with recourse to equations. The resulting microhardness variation with position throughout the as-cast materials and cooling rate were characterized by experimental power laws. Results determined after the solidification experiments have revealed microhardness as a function of both cooling rate and position (P) of the as-cast materials to be dependent on alloy composition. In the ECAP process via route C with three passes, “as-solidified” microstructures have been found to be distorted and fragmented during the severe plastic deformation. This deformation imposed on the billets during the ECAP process facilitated obtaining a fine microstructure and high levels of microhardness were observed. However, even with the ECAP process, it was shown that microhardness is strongly dependent of the cooling rates.

Keywords

• Equal-channel angular pressing
• ultrafine-grained alloys
• microhardness
• solidification