Thermal Treatment Effect on Tribological and Corrosion Performances of 13Cr5Ni2Mo Super-Martensitic Stainless Steel

S. Tlili; N.E. Beliardouh; C.E. Ramoul; R. Bahi; O.I. Abdullah; H. Kaleli; M.A. Samad

doi:10.24874/ti.2018.40.03.09

Tribology in Industry (Sep 2018)

Thermal Treatment Effect on Tribological and Corrosion Performances of 13Cr5Ni2Mo Super-Martensitic Stainless Steel

S. Tlili,
N.E. Beliardouh,
C.E. Ramoul,
R. Bahi,
O.I. Abdullah,
H. Kaleli,
M.A. Samad

Affiliations

S. Tlili: Research Center in Industrial Technologies CRTI P.O.Box 64, Cheraga 16014 Algiers, Algeria
N.E. Beliardouh: Laboratoire Ingénierie des Surfaces (LIS), Université Badji Mokhtar, BP 12, 23000, Annaba, Algeria
C.E. Ramoul: Research Center in Industrial Technologies CRTI P.O.Box 64, Cheraga 16014 Algiers, Algeria; Laboratoire Ingénierie des Surfaces (LIS), Université Badji Mokhtar, BP 12, 23000, Annaba, Algeria
R. Bahi: Laboratoire Ingénierie des Surfaces (LIS), Université Badji Mokhtar, BP 12, 23000, Annaba, Algeria
O.I. Abdullah: Department of Energy Engineering, College of Engineering, University of Baghdad, Iraq
H. Kaleli: Faculty of Mechanical Engineering, Automotive Division, Yıldız Technical University, Istanbul, Turkey
M.A. Samad: Department of Mechanical Engineering, King Fahd University of Petroleum and Minerals, Dhahran – 31261, KSA

DOI: https://doi.org/10.24874/ti.2018.40.03.09
Journal volume & issue: Vol. 40, no. 3
pp. 433 – 439

Abstract

Read online

Wear behavior of 13Cr5Ni2Mo supermartensitic stainless steel (SMSS) were investigated in air and in argillaceous paste at room temperature. Prior to wear testing, the samples were subjected to two thermal treatments, namely; quenching followed by double tempering. A pin-on-disc test rig was used to conduct the wear test with a tribo-pair consisting of supermartensitic stainless steel sliding against itself. It was observed that the microstructure of the thermally treated samples mainly consisted of tempered martensite and carbides. Wear results showed that oxidative and abrasive wear dominated the wear process of the treated samples in both dry conditions and in argillaceous paste. Additionally corrosion tests were performed in 5.0% NaCl solution via potentiodynamic polarization tests. It was found that the passive film formation provides a good corrosion resistance to the samples.

Published in Tribology in Industry

ISSN: 0354-8996 (Print); 2217-7965 (Online)
Publisher: University of Kragujevac
Country of publisher: Serbia
LCC subjects: Technology: Mechanical engineering and machinery
Website: http://www.tribology.fink.rs/

About the journal

Abstract

Keywords