Effects of TiAlN Coating Thickness on Machined Surface Roughness, Surface Residual Stresses, and Fatigue Life in Turning Inconel 718

Abstract

The surface roughness and surface residual stresses are affected by the coating thickness of physical vapor deposition (PVD) TiAlN tools, which could alter the service performance of machined components. However, the relationships among the tool coating thickness, the machined surface roughness, the surface residual stress, and the fatigue life are still not sufficiently illustrated. In this research, PVD TiAlN coatings with several thicknesses of 1.6 μm, 2 μm, 2.5 μm, and 3 μm were deposited on carbide tools. Turning experiments using Inconel 718 were conducted with uncoated and various TiAlN tools under flood cooling conditions. The surface roughness could be improved with the selection of thin PVD TiAlN coating thicknesses of 1.6 μm and 2 μm compared to that of uncoated tools. The tensile residual stresses at the machined surface in the directions of cutting speed and feed rate linearly decreased by 148.67% and exponentially decreased by 92.24% when the TiAlN coating thickness was increased from 0 μm to 3 μm. The values of the low-cycle fatigue life of machined Inconel 718 linearly increased by 15.60% with the increase in TiAlN coating thickness from 0 μm to 3 μm, which was mainly due to the improvement of surface residual stresses. The results could provide guidance for the selection of suitable TiAlN coating thicknesses for wet machining Inconel 718 based on the part service conditions.

Keywords

• coating thickness
• machined surface roughness
• residual stress
• fatigue life
• Inconel 718