Comparing Deterministic and Stochastic Methods in Geospatial Analysis of Groundwater Fluoride Concentration

Abstract

Dental and skeletal fluorosis caused by consuming high-fluoride groundwater has been reported over several decades globally. Prediction maps to estimate the fluoride contaminated area rely on interpolation methods. This study presents a comparison of the accuracy of nine spatial interpolation methods in predicting the fluoride in groundwater. Leave-one-out cross-validation (LOOCV), hold-out validation and validation with an independent dataset were used to assess the precision of the interpolation methods. This is the first study on fluoride with a large dataset (N = 13,585) applied at the regional level in India. Our findings showed that the inverse distance weighted (IDW) algorithm outperformed other methods in terms of less discrepancy between measured and predicted fluoride. IDW and local polynomial interpolation (LPI) were the only methods to predict contaminated areas (fluoride > 1.5 mg/L). However, the area estimated by the typical assessment of the percentage of unsuitable samples was much higher (6.1%) compared to that estimated by IDW (0.2%) and LPI (0.2%). LOOCV provided viable results than the other two validation methods. Interpolation methods are accompanied with uncertainty which are regulated by the sample size, sample density, sample distribution, minimum and maximum measured concentrations, smoothing and border effects. Drawing a comparison among variegated interpolation methods capturing a wide range of prediction uncertainty is suggested rather than relying on one method exclusively. The high-fluoride areas identified in this study can be used by the Government in planning remediation actions.

Keywords

• fluoride
• drinking water
• health risk
• geology
• aquifer
• interpolation analysis