Discrete Spectrum cover Signal Waveform Design and Generation Method
Jianglan TANG,
Jialei LIU,
Jiazhi MA,
Longfei SHI,
Yifu GUAN
Affiliations
Jianglan TANG
State Key laboratory of Complex Electromagnetic Environmental Effects on Electronics and Information System, College of Electronic Science and Technology, National University of Defense Technology, Changsha 410073, China
Jialei LIU
State Key laboratory of Complex Electromagnetic Environmental Effects on Electronics and Information System, College of Electronic Science and Technology, National University of Defense Technology, Changsha 410073, China
Jiazhi MA
State Key laboratory of Complex Electromagnetic Environmental Effects on Electronics and Information System, College of Electronic Science and Technology, National University of Defense Technology, Changsha 410073, China
Longfei SHI
State Key laboratory of Complex Electromagnetic Environmental Effects on Electronics and Information System, College of Electronic Science and Technology, National University of Defense Technology, Changsha 410073, China
Yifu GUAN
State Key laboratory of Complex Electromagnetic Environmental Effects on Electronics and Information System, College of Electronic Science and Technology, National University of Defense Technology, Changsha 410073, China
Radio Frequency-screen is one of the earliest radar active antijamming measures. It achieves antijamming by transmitting cover pulses of different frequencies before the radar pulse signal to induce enemy jammers. As the demand for antijamming measures has become increasingly urgent in recent years, Radio Frequency-screen technology has been further developed. The most representative is the use of discontinuous spectrum signals as a cover signal. However, energy utilization for sending the cover signal can be improved further. To address this problem, this paper proposes a discrete spectrum cover signal based on the discontinuous spectrum cover signal and establishes the waveform design function under the joint constraint of constant modulus and spectral amplitude. The cover signal with discrete spectrum and energy aggregation is generated using the Alternating Direction Method of Multipliers (ADMM) and spectrum shaping algorithm solution. The simulation results show that the discrete spectrum cover signal has a higher spectral amplitude of approximately 5～12 dB than the discontinuous-spectrum cover signal for the same energy and bandwidth. Moreover, the discrete spectrum cover signal can cover a larger spectral range with the same energy and close spectral amplitude, realizing a better antijamming cover effect.
